Beef Eye Round

Once again we were having a few people over and this time they mentioned that they have never tried an eye round cut of beef. So I said bring some red wine over and I’ll show you what to do and we will put it on the rotisserie and enjoy the sun set! So we headed to the kitchen and here is what we did.

First, take the meat out of the plastic it’s wrapped in, I like to rinse off the blood, plus it makes it less slippery when you are handling it.

Trim off the silver skin but try to leave the fat strip intact. While cooking, the fat will melt and baste the meat as it spins around.

Fire up the rotisserie burner, close the lid and preheat the grill for twenty minutes.

This is where I cheat a little; I already have marked the rod so I know where the meat should be and I season the meat on the grill because it keeps the mess out of the kitchen and whatever doesn’t stick just falls into the grill anyway.

20140228_175519

So I rub some oil on the meat, slather on some finely chopped garlic and some Montreal Steak seasoning outside, then check that it spins freely.

20140228_181132

Forget about it for about an hour. After an hour take a meat thermometer and insert it in the middle of the meat ½ way between the outside and the rod in the center. You are looking for about 110F degrees if you like rare meat. If you test out at 110F turn off the burner but let the meat keep spinning for about 20 minutes. This allows the juices to be reabsorbed back into the meat so when you slice it the juices don’t leak out onto the cutting board.

Honestly I think I served the meat with some basmati rice, some grilled vegetables and some fresh homemade horseradish sauce. Good friends, good conversation and good wine led me to forget to take a finished picture after all. Trust me it was delicious!

20140228_200539

Enjoy ~